FAQs
Why am I unable to pair my RR-RECEIVER with the RR-1BUTTON Wireless Remote Release Button or the RR-4BKEYFOB Wireless Remote Release Keyfob?
Wire the RR-RECEIVER to the locking device you wish to control using as required. Perform the following steps precisely:
1. Press and release the RR-RECEIVER button. Ensure the green LED turns on.
2. On the Wireless Remote Release, press and hold a button until the green LED begins to flash, then release the button.
3. Observe the LED on the Wireless Remote Release for the pairing status (Red=pairing failure, Green=pairing successful).
4. Press the RR-RECEIVER button (its LED will flicker and turn off).
Press the button on the Wireless Remote Release to test.
- If this RR-RECEIVER is being used with a Trilogy T2 lock (excluding 1200 series), then you have completed the pairing process.
- If this RR-RECEIVER is being used with a Trilogy T3 lock (excluding Networx and 1300 series), then perform the following steps:
5. At the Trilogy T3 lock keypad, enter Program Mode pressing the Master Code followed by [AL] key.
6. Press [AL] [6] [5] [*] to enable the lock's Remote Input feature. Exit Program Mode.
Press the button on the Wireless Remote Release to test.