Results Per Page | Showing 1-19 of 19 Results
| 1
Answer:
These keypads only support EZM addresses 1 through 22.
View Answer
Answer:
If multiple GEMC-FK1 keypads are in one system, only one GEMC-FK1 keypad can be unlocked at a time. If switching to another keypad, re-lock the keypad not in use.
...
View Answer
Answer:
NO... the keypad data received by the controller will be identical as a 26 bit Prox card. You do not have to Enable the keypad under Readers.
View Answer
Answer:
Each keypad can be addressed up to EZM address 22.
...
View Answer
Answer:
As noted in the Gemini Keypad Data Sheet WI1978, the backlight cannot be dimmed; however, it can be disabled by cutting jumpers W1, W2 and W3 (see image).
View Answer
Answer:
For consistency, it is recommended that all keypads either be all "classic" (such as the GEM-RP1CAe2 keypad) or all "K Series" (such as the GEM-K1CA)--both keypad types should not be used in one alarm system.
View Answer
Answer:
Yes! Use the GEM-RPB5 Keypad Junction Box Mounting Kit (see instructions).
...
View Answer
Answer:
Yes, with the alpha keypads, you can independently turn off the backlighting of the LCD display and/or the backlighting of the keypad buttons. If you wish to reduce the keypad LCD backlighting intensity, you may only reduce the backlighting of the...
View Answer
Answer:
In "Keypad Configuration," you can program the keypad up to EZM address 22. For any Gemini control panel utilizing more than 22 EZMs, we recommend using the GEM-EZM8 for the additional EZMs. The maximum number of supported EZMs for each...
View Answer
Answer:
The Reset jumper is located on the 3rd and 4th terminal (counting from the top of unit).
View Answer
Answer:
Yes. You can still use your old keypads and they will function normally, but you will not be able to access User Programming Mode nor Dealer Programming Mode.
View Answer
Answer:
Parts List
PG30KPD Keypad
PG30KPD Extension Cable
2 Keypad Adapter Module
Single Gang Box
Paperwork
Installation Instructions WI773
View Answer
Answer:
Napco does not recommend wiring both "K Series" and "Classic" style keypads to the same control panel, but if both styles are in fact used in one system, the rule is:
...
View Answer
Answer:
Arm your alarm system with a Gemini "Classic" keypad as follows:
...
View Answer
Answer:
When programming the control panel using a keypad with an LED display, you may experience difficulty due to a "Program Mode beep" that sounds every 15 seconds when the system is in User or Dealer Program Mode.
...
View Answer
Answer:
To change the system keypad type from "Classic" to "K Style", first wire a new "K Style" keypad to the control panel. Note that there is no need to remove the "Classic" keypad(s) that are already in the system. Next, on the new "K Style"...
View Answer
40 Results Per Page | Showing 1-19 of 19 Results
| 1
