FAQs
What should I check if the Veri-Phone "Auto-sense Mode" is not working properly?
When using the "Auto-sense Mode" with Veri-Phone, the following is necessary:
1. Wire the telephone lines as shown on page 8 of the Veri-Phone manual. It is critical that one side of the incoming Telco line be broken by terminals 24 and 25, as shown. This is where the flow of current is sensed when the control panel seizes the line, triggering the Veri-Phone.
2. In control panel programming, Block [#] [4] must be programmed with a "1" in the first location: ( [#] [4] = [1] [0] [0] [0] [0] [0] [*] ).
After the above two items are performed, ensure the Veri-Phone LED is flashing on for 2 seconds, and then off for 2 seconds. Also verify the taking of a house phone off-hook results in a steady Veri-Phone LED.