FAQs
When using a Magnum Alert or Gemini control panel Wizard, the message reads "Caution, out of system". What should I check?
The "Wizard 1" (marked as just "Wizard"), is only for use with the Magnum Alert MA1000 series control panels. Only the "Wizard 2" works with the Gemini GEM-P3200 and GEM-P9600 control panels.
When using the "Wizard 2" with a GEM-P3200 or GEM-P9600 control panel, the following must be done:
1. Program the control panel for an additional keypad (if there are already two keypads in the system, program a third keypad).
2. Program the "Wizard 2" as the appropriate keypad address (if the "Wizard 2" is to be used as keypad 3, program the "Wizard 2" Limit 6 as 003: ( [*] [2] [6] [*] [0] [0] [3] [#] [#] ).
This is the minimum programming required to activate the "Wizard 2" for use with the Gemini GEM-P3200 and GEM-P9600 control panels.