FAQs
How do I wire up one 8 door panel to another 8 door panel using RS-422 in REPEAT mode?
Notes:
1) Maximum 4000 feet between each panel.
1st Panel 2nd Panel
(RT+) Pin 7 ----------------------------------------------------------Pin 13 (MR+)
(RT-) Pin 8 -----------------------------------------------------------Pin 14 (MR-)
(RR+) Pin 9 ----------------------------------------------------------Pin 11 (MT+)
(RR-) Pin 10 ----------------------------------------------------------Pin 12 (MT-)
Important Notes:
- Repeat pins on the first panel, connect to Multidrop pins on the second panel.
- (T)ransmit pins on the first panel, connect to (R)eceive pins on the second panel.
- (R)eceive pins on the first panel, connect to (T)ransmit pin on the second panel.
- Polorities on the first panel, connect to the same polarities on the second panel (ex. + to +) and (- to -)
- Place the mode jumper in the "Repeat" position.
- Place the EOL2 jumper in on all panels.
Note: Refer to the Panel Installation and Service manuals for complete wiring diagrams. If you are wiring up repeat mode on an Accelaterm, you can only repeat to an Accelarator or a CICP2100. The Accelerator should be plugged on to the Turbo Superterm. Repeating an Accelaterm to a Super Two or a legacy panel is not recommended due to a difference in packet sizes.