FAQs
How do I wire up three panels in repeat mode with the first being an 8 door panel, the second a Super Two and the third being an 8 door panel?
Note: In repeat mode, the maximum distance between panels is 4000 feet.
VERY IMPORTANT - ONLY ACCELATERMS, CICP2100S AND ACCELERATORS CAN REPEAT TO EACH OTHER. THESE TYPES OF CONTROLLERS CANNOT REPEAT TO SUPER TWO'S OR ANY OTHER TYPES OF CONTROLLERS.
1st panel (8 door) 2nd Panel (Super Two) 3rd Panel (8 door)
RS422 Connector
(RT+) Pin 7 ----------------------- (MR+) (RT+)---------------------Pin 13 (MR+)
(RT-) Pin 8 ----------------------- (MR-) (RT-) ---------------------Pin 14 (MR-)
(RR+) Pin 9 ---------------------- (MT+) (RR+)---------------------Pin 11 (MT+)
(RR-) Pin 10 --------------------- (MT-) (RR-)----------------------Pin 12 (MT-)
Important Notes:
- Repeat pins on the first panel connect to Multidrop pins on the second panel.
- (T)ransmit pins on the first panel, connect to (R)eceive pins on the second panel.
- Polarities on the first panel connect to the same polarity on the second panel (ex. + to +)
- Place the mode jumper on all panels to "Repeat" position
- Place the EOL2 to the In position