FAQs
Why is my Accelerator not working after plugging it into a Turbo Superterm or Superterm board?
Please verify the following:
1) Verify that no pins got bent while plugging the Accelerator board in.
2) Verify resistor (R62) is cut on the Turbo Superterm /Superterm board as per the instructions.
3) Verify the Accelerator Firmware (Accel.img) firmware is download to the Accelerator board. The Accelaterm firmware does not download automatically. You must initiate the download manually through Configuration>Panels>Download>Firmware downloads.
Note: You must view the communications driver to verify there has been firmware downloaded to the panel.