FAQs
How do I mount a GEMC-FW-SLC module inside the small FireLink enclosure?
As detailed below, mount the GEMC-FW-SLC module to the HW1489 Battery Shelf with the hardware provided.
Before mounting the GEMC-FW-SLC module inside the control panel enclosure, orient the GEMC-FW-SLC module so that the "ADDR" dip switches and "RELAY" dip switches are located on the right side of the PC board. The following instructions also appear in the GEMC Control Panel Installation Instructions (Vol. 1):
Install the SLC Module as follows:
- Insert four SC631 screws (item 7) such that the threads protrude from the bottom of the HW1489 battery Shelf as shown. Secure the screws into the SO216 Spacers (item 6) as shown.
- Place the PC Board on top of the SO216 Spacers and secure with the 6-32 kep nuts (item 5) as shown. Do not over-tighten nuts.
