FAQs
Can the IBR-ZREMOTE Z-Wave Controller run with a Savant Home Automation system?
Yes, the NAPCO IBR-ZREMOTE Z-Wave Controller can integrate with a Savant Home Automation system, allowing a Savant system to take full advantage of NAPCO's security system and all of its associated features. Below is a list of required firmware, equipment and control panels:
Savant Integration
Supported Control Panels & Required Firmware
- Gemini GEM-P3200, GEM-P9600 and GEM-X255 (with NO e-prom) must be running version 72C or greater
- Gemini GEM-P3200, GEM-P9600 and GEM-X255 (with e-prom) must be running version 61A or greater
- Gemini GEM-P816, GEM-P1632 and GEM-P1664 must be running version 31B or greater
iBridge IBR-ZREMOTE - Must install an A-IBR-ZREMOTE or use the below specialized firmware:
- RCM: Use version RH7
- Z-WAVE: User version 6178
To update your existing IBR-ZREMOTE, activate your iBridge account on www.NapcoComNet.com. Log into your www.iBridgeonline.com dealer account and flash the correct firmware version remotely.
Note: When configuring an IBR-ZREMOTE to run with a Savant System, be aware that the automation IP port is the port located on the right side of the IBR-ZREMOTE module. This MAC address normally starts with D4 (also printed on the back of the unit); this port is the IP Port that communicates over IP to your Savant System.