FAQs
When using a monitor zone as a tamper on a Gemini C-Series (GEMC) control panel, how do I program for auto reset?
When using a Monitor zone as a tamper and you do not want to use the keypad to reset the zone, program as follows:
- Enable the Monitor zone for the specific zone number as needed.
- Make sure that you wire the tamper switch for normally closed operation.
When the tamper switch is closed, the zone will go into trouble. When the switch is re-opened, the zone auto resets. If a direct short is applied, the zone will go into alarm and the keypad will be needed to reset the zone.