Results Per Page | Showing 1-4 of 4 Results
| 1
Answer:
Connect the purple wire from the FW-RM1 to the control panel positive Bell terminal.
...
View Answer
Answer:
No, after the control panel is programmed, the AutoLearn feature can no longer be used. A workaround would be to not use SLC addresses one through eight; start your SLC addressing at number nine, then after AutoLearning and uploading the...
View Answer
Answer:
Turn on a blow dryer to its highest "heat" setting and hold 12 inches from the top side inlets of the FWC-FSLC-HEAT detector. Maintain the hot air flow into the inlets until the lights turn red and unit goes into alarm. Turn off the...
View Answer
40 Results Per Page | Showing 1-4 of 4 Results
| 1
