Results Per Page | Showing 1-12 of 12 Results
| 1
Answer:
Resetting the iSecure control panel back to its factory default settings ("Cold Start") will leave your iSecure panel with a blank program. We STRONGLY recommend that before you begin, that you first back up your panel program to the iSecure Cloud...
View Answer
Answer:
Yes! A hardwired siren can be wired to the Bell terminals located on the rear of the iSecure Go-Anywhere Hub (supervised using a 2.2K ohm resistor).
...
View Answer
Answer:
Yes! A standard hardwired siren can be wired to the bell terminals located at the rear of the iSecure Go-Anywhere Hub, and supervised using a 2.2kΩ resistor.
...
View Answer
Answer:
Yes, you can hardwire a GEMWV-RECV to the iSecure Go-Anywhere Hub terminals. This GEMWV-RECV receiver is compatible with the iSecure 319.5MHz frequency.
...
View Answer
Answer:
The iSecure Cloud Web Portal is located at www.iSecureByNapco.com. To log in to the website, have your ComNet dealer login and the iSecure "Radio ID" number handy. The Radio ID is located on the small card (part "OI404LF") included with the...
View Answer
Answer:
You have a choice of a wireless keypad model (ISEC-WL-KEYPAD), a 4.3-inch color touchscreen (ISEC-WL-TOUCH) or a 7-inch touchscreen tablet (IBR-TOUCH-WL).
...
View Answer
Answer:
Yes, absolutely!
iSecure supports all of the Gemini wireless transmitters.
Note: iSecure does not support point 2 of the GEM-TRANS2.
View Answer
40 Results Per Page | Showing 1-12 of 12 Results
| 1
