Results Per Page | Showing 1-22 of 22 Results
| 1
Answer:
Important: Only GEN3 Gateways are eligible for conversion to MVP Access. The uniVerse Finder Utility Software must be installed on the same local area network as the gateway.
...
View Answer
Answer:
NO - You must use the AL-IM2 or AL-IM3 Gateways with the CA3000 or CA4K software.
The Air Access Gateways have an Air Access sticker on them, and can't be used with the CA3000 or CA4K software.
View Answer
Answer:
The "Enable Wireless Locks" checkbox only displays on a CA4K Host and on an additional HCS (Com Server). The "Enable Wireless Locks" checkbox will never display on a Workstation. Please verify that you are not on a Workstion.
View Answer
Answer:
An acceptable Signal Strength range for Networx Wireless locks is >32 and <90.
View Answer
Answer:
Yes, it is a new feature in CardAccess 3000 V2.9.88 and it's also available in the CA4K. There is a one button and a four button remote release available.
...
View Answer
Answer:
NO...On earlier versions of software it was a requirement. As 0f 2018, you can manually add a gateway in and specify any subnet you wish to. While programming, the Gateway does not have to be on the same subnet as the CA4K software.
...
View Answer
Answer:
You can have up to 7 Expanders with 1 Gen II gateway. The gateway and up to 7 expanders must be addressed to the same group number.
View Answer
Answer:
YES...
If a trilogy Wireless Lock, Gateway or Expander is reset, it MUST be rediscoved and added back into the CardAccess 3000 software.
View Answer
Answer:
The Blue Card is the Gateway ID card. It is very important to keep this in a safe place.
...
View Answer
Answer:
VERY IMPORTANT: Keep this yellow card in a safe place. The yellow card is the LOCK ID card. This card will contain the LOCK ID of the lock. A lock ID label will also be on the internal chassis of the lock. While discovering and Adding in Locks,...
View Answer
Answer:
To reset (default) a Trilogy Networx lock that contains a keypad, perform the following steps:
...
View Answer
Answer:
Below are the partial part numbers for the 3 different types of Networx Exit Trims that Continental offers. Take note of the N in the partial and full part numbers below. It is in the fifth position. (THIS REPRESENT NETWORX and Continental...
View Answer
Answer:
The "Double Tap" feature works identical for Wireless Locks with Prox readers and Continental Controllers with the latest firmware as of V2.11.84 and all versions of the CA4K software. For this function to work, you must select "Double read holds...
View Answer
Answer:
This was done by design. People have a habit of pressing keys on Wireless locks when they walk down a hallway. This was to prevent bogus alerts from displaying when someone presses a key unintentionally. Future releases of CardAccess 3000 might...
View Answer
Answer:
The battery for these locks have been redesigned. On the PDL6200 and the PL6200, the existing cover needs to be shaved down, or you need to Contact Continental Access to get a replacement cover.
...
View Answer
Answer:
1) If the wireless lock is communicating via a hardwired ethernet cable, and there is a wireless card in the PC, you must make the direct connect ethernet adapter the first adapter in the binding list.
...
View Answer
Answer:
CA4K support all the models listed below.
...
View Answer
40 Results Per Page | Showing 1-22 of 22 Results
| 1
