Results Per Page | Showing 1-10 of 10 Results | 1

What can cause a badge to be disabled on the first swipe and then enabled when swiped again?

Answer:
If the reader is configured for a BADGE VALIDATOR, it will disable the badge on the first swipe and then enable it on the next swipe. In almost all cases, the reader type should be configured for a DOOR.

How does Degrade Mode function in the CA3000 and the CA4K?

Answer:
If you are using facility codes, it will check the facility code and if that's correct, it will grant access no matter what the badge number is. 
...

What does the alert "Panel Trouble - Test Fail" mean?

Answer:
A "Panel Trouble - Test Fail" alert might be caused by a defective EPROM (Firmware Chip).  

What can cause a "Trouble Line Fault" alert to display?

Answer:
A trouble line fault is caused by a shorted input wire. You must verify if the input is being used and if there are wires on it. If so, you should remove the wires and place a jumper across the input. At this point, you need to verify if...

What can cause an alert/event not to display when a badge is swiped at a reader?

Answer:
Summary: There are multiple reasons why an event would fail to display. In the CardAccess 3000 software, verify the following:
...

What can cause a "Badge Violate Unauthorized" alert message to display?

Answer:
Summary: This alert message will display if there is a record of the badge in the database and the badge belongs to at least one reader on the panel but not the reader it was swiped at. 
...

What can cause a "Badge Violate Time Of Day" alert message to display?

Answer:
Summary: This alert message displays when the badge is programmed to be active at a given time, but the badge was swiped outside of the allowed time schedule. In the CardAccess3000 software, verify the following settings:
...

What can cause a "Badge Violate Void At Panel" alert message to display?

Answer:
Summary: This error message means there is a record of the badge in the database, but the badge does not belong at any reader on the panel.
...

What can cause a "Badge Violate Facility" alert message to display?

Answer:
Summary: This alert message normally displays when the facility codes are configured properly, but the facility code is not a match.  In the CardAccess 3000 software, verify the following settings:
...

What can cause a "Badge Violate Void" alert message to display?

Answer:
Summary: This alert message normally means there is no CardAccess database record for the badge. In the CardAccess 3000 software, verify the following settings:
...

40 Results Per Page | Showing 1-10 of 10 Results | 1