Results Per Page | Showing 1-10 of 10 Results
| 1
Answer:
YES - Remove the reader wiring from the reader port. On the controller, you should read +5V between D0 to Gnd and 5V between D1 to GND.
If you do not measure 5 volts, you will have to replace the board.
View Answer
Answer:
YES - The CA4K will support a 4 or 8 bit burst keypad. In the early days of CA3000, it only supported a 4 bit burst, but eventually it was updated to support either a 4 bit burst, or a 8 bit burst keypad.
View Answer
Answer:
If you are not using a keypad, you must verify the Keypad is NOT enabled under Readers>Door Control.
View Answer
Answer:
1) Max characters allowed on a Magstripe is 75 characters.
...
View Answer
Answer:
NO...The Accelaterm does not offer an XY interface. Note: Most newer controllers do not support XY Matrix keypads.
View Answer
Answer:
If there is too much power being drawn on the +12volts or +5volts, the Continental Controller will beep. If this occurs, remove the keypad or reader immediately.
View Answer
Answer:
Like any electronic device, it's always recommended to cycle the power on the reader/keypad.
View Answer
Answer:
When an external voltage is supplied to a reader/keypad, you MUST common the grounds between the power supply ground and the ground on panel.
View Answer
Answer:
There are many types of keypads available, which determine the different modes available. Below are 4 different supported modes.
...
View Answer
40 Results Per Page | Showing 1-10 of 10 Results
| 1
