Results Per Page | Showing 1-4 of 4 Results
| 1
Answer:
Wire a door contact to ACM terminals 25 and 26 on the GEM-ACM1D (terminals 43 and 44 on the GEM-2D with a 2.2K EOLR. The same or separate zones can be used, depending on how the conditions are desired to operate. The zone or zones must...
View Answer
Answer:
The GEM-ACM1D is pre-configured at the factory for 26-bit proximity cards and readers; however, if you wish to use Napco cards and readers, you must check the Napco Proprietary Access Format checkbox in the Quickloader Keypad Assignment screen, ACM...
View Answer
Answer:
Using PCD-Windows Quickloader, go to the Keypad Assignment screen, ACM Assignment tab. Uncheck both the Arm All Areas Allowed and Disarm All Areas Allowed checkboxes (as shown in the image below). After downloading these changes to the...
View Answer
40 Results Per Page | Showing 1-4 of 4 Results
| 1
