Results Per Page | Showing 1-8 of 8 Results
| 1
Answer:
Yes! When a fire alarm activates, the Heating, Ventilation, and Air Conditioning (HVAC) system is generally required to be shut down to prevent the spread of smoke and fire. After a fire alarm-triggered shutdown, the HVAC system does not...
View Answer
Answer:
NFPA 72 and UL 864 prohibit remote downloading to a Fire Alarm Control Panel unless a qualified technician is physically at the control panel installation site. To ensure a technician is on site, the Fire system keypad must first be unlocked...
View Answer
Answer:
Models: All FireLink, Firewolf* and GEMC* Fire Panels (FL-xxx, FLX2-xxx, GEMC-FW-xxx, GEMC-COMBOxxx)
...
View Answer
Answer:
To set up a FWC-FSLC-SOM1-E Supervised Output Module in place of a NAC Extender with GEMINI GEMC series control panels (including Firewolf and FireLink panels), you will need a fire-rated 24VDC power supply and, possibly, a sync module for the...
View Answer
Answer:
Yes. To provide constant power for magnetic locks and other powered devices, you can program either the FireLink control panel NAC D integral output or you can program the NAC Extender GEMC-NAC7 PC board, as follows:
...
View Answer
Answer:
As detailed below, mount the GEMC-FW-SLC module to the HW1489 Battery Shelf with the hardware provided.
...
View Answer
Answer:
The Napco FWC-FSLC-CZM Conventional Zone Module allows the control panel fire SLC (Signaling Line Circuit) loop to interface with and monitor two-wire conventional detectors or pull stations. When used with the GEMC-F8ZCPIM Conventional 8 Fire...
View Answer
40 Results Per Page | Showing 1-8 of 8 Results
| 1
