Results Per Page | Showing 1-11 of 11 Results
| 1
Answer:
If you are experiencing signals that are slow to appear at the central station, the Signal Log will likely provide the information you need to clarify the issue.
...
View Answer
Answer:
In UL Listed Burglary installations, the control panel keypad must annunciate when the StarLink communicator goes into trouble, not solely when there is Telco line trouble or a 'fail to communicate' trouble.
...
View Answer
Answer:
We recommend that you consider an external power supply for your system if the power draw is close to the maximum allowed by the control panel.
...
View Answer
Answer:
The Test Timer feature is an automatic test report sent to the central station at the same time, either daily, weekly, or monthly. A feature of all fire or burglary control panels, the Test Timer feature tests the ability of the control panel (and...
View Answer
Answer:
The 4/2 reporting format requires the use of a dial up receiver telephone number as you cannot use 4/2 to report to SurGard, Bosch or VIP receivers. Contact ID format is required for IP reporting. Go to the StarLink Radio Management Center (in the...
View Answer
Answer:
Auto Disarming is not available with the GEM-P1632, GEM-P816 or GEM-P1664 control panels, however this scheduling feature is available with the GEM-P3200, GEM-P9600 and GEM-X255 control panels.
...
View Answer
Answer:
If you wish to use the iBridge IBR-ZREMOTE module, other iBridge system components or a StarLink Connect Communicator with an older GEM-P816 or GEM-P1632 control panel running firmware version 10D, this older control panel firmware must be upgraded...
View Answer
Answer:
There are several communication methods you can use to connect to your existing control panels:
...
View Answer
Answer:
The Gemini GEM-P3200, GEM-P9600 and GEM-X255 control panels running firmware version V70 and above have a prom chip that can be flashed for firmware upgrades (instead of a chip change). The existing control panel version can be verified by...
View Answer
Answer:
In PCD-Windows Quickloader, check the User Assignment screen, User Report Open/Close tab. Ensure Keyswitch Arming is checked to report openings and/or closings.
...
View Answer
Answer:
Configure the control panel as follows:
...
View Answer
40 Results Per Page | Showing 1-11 of 11 Results
| 1
