Results Per Page | Showing 1-17 of 17 Results
| 1
Answer:
These two boards almost look identical. There is one easy way of telling. There is a crystal on both boards. The crystal is labeled Y1. If the value of Y1 is 22.11MHz, then it would be a Turbo Superterm. If its 11.05MHz then it would be a...
View Answer
Answer:
Turbo Superterm = Up to 3 Expansion boards
Super Two - Up to 3 Expansion boards
Accelaterm - The 8 door model supports up to 3 expansion boards. The 16 door model supports only 2 expansion boards.
View Answer
Answer:
When upgrading to CA4K, there are two chips on older Superterms that might need to be updated. Below are the two chips to be concerned with:
...
View Answer
Answer:
Inputs on a 4 Door Turbo Superterm and a 4 Door Superterm map identical to a Smarterm. Using the wrong input numbers is a very common error that users make. For instance, the auxialary inputs on the top left of the board are...
View Answer
Answer:
Refer to the Accelaterm Service and Installation manual.
...
View Answer
Answer:
There are 4 firmware images in the CardAccess 3000 folder and CA4K folder. The files are smart.img, smart2.img, super2.img, cicp2100.img and accel.img.
...
View Answer
Answer:
Yes...Virtual Inputs are available on the 8 and 16 door Accelaterm. They are only available on the first 8 readers on both models (8 or 16 Door). The virtual input numbers for the first eight readers map identical to the Turbo Superterm and...
View Answer
Answer:
Note: An 8 door Accelaterm can have up to 3 I/O expansion boards connected to it. A 16 door Accelaterm can only have 2 I/O expansion boards connected to it. Each I/O expansion board contains 16 additional inputs and 16 additional...
View Answer
Answer:
Below is a list of Maximum baud rates for the Continental Controllers?
...
View Answer
Answer:
The T2 light is used to display the status of Auto-Baud. The T2 light will flash as the board is sequencing through different baud rates. When it locks on to a baud rate, the light can be on solid or completely off depending on the baud rate the...
View Answer
Answer:
Accelaterm = NO
Turbo Superterm = NO
Superterm = NO
Super Two = YES
The Super Two is the only controller where the inputs have a common ground.
View Answer
Answer:
There are two jumpers per strike relay. You must set both jumpers to either Local or Remote. If you want to use Local strike power, you must feed power into the (STKPWR) connector on the bottom of the board and also set both jumpers to Local.
...
View Answer
Answer:
The Continental Polling cable contains 3 wires (purple, red and brown).
...
View Answer
40 Results Per Page | Showing 1-17 of 17 Results
| 1
