Results Per Page | Showing 1-14 of 14 Results
| 1
Answer:
We recommend that you consider an external power supply for your system if the power draw is close to the maximum allowed by the control panel.
...
View Answer
Answer:
To test the programming of an existing Test Timer feature:
...
View Answer
Answer:
The GEM-P800 and GEM-P801 control panels are equipped with a 3-wire bus, therefore the only devices that are compatible are:
...
View Answer
Answer:
The User Codes that you were unable to change or delete were programmed with Blocked View, allowing them to be viewed but not changed or deleted.
...
View Answer
Answer:
If you wish to use the iBridge IBR-ZREMOTE module, other iBridge system components or a StarLink Connect Communicator with an older GEM-P816 or GEM-P1632 control panel running firmware version 10D, this older control panel firmware must be upgraded...
View Answer
Answer:
If the total power draw from all connected devices exceeds the power rating of the control panel, install an auxiliary power supply as follows:
...
View Answer
Answer:
Yes, Test Timer programming can be performed using the keypad only when the following are both true:
...
View Answer
Answer:
Normally the control panel sends a Test Timer report daily, but if you prefer a weekly test, or an 8 hour test, or a 1 hour test, program as follows:
...
View Answer
Answer:
It is always important to be mindful of and to calculate the total auxiliary power draw from all connected devices. Overdrawing control panel power can damage the control panel or cause unpredictable troubles and false alarms.
...
View Answer
Answer:
With control panels GEM-P3200, GEM-P9600 and GEM-X255, wire the device power to the auxiliary power supply DC positive and negative. Then install a wire between the auxiliary power supply DC negative and control panel common (either terminal 10...
View Answer
Answer:
Wire the power to the devices to the auxiliary power supply’s DC positive and negative. Then install a wire between the auxiliary power supply DC negative and panel common (either terminal 6 or terminal 10 will work with the GEM-P816,...
View Answer
Answer:
The "Wizard 1" (marked as just "Wizard"), is only for use with the Magnum Alert MA1000 series control panels. Only the "Wizard 2" works with the Gemini GEM-P3200 and GEM-P9600 control panels.
...
View Answer
Answer:
EZ Arm provides one button arming for non-security critical premises. Disarming still requires a valid user code.
...
View Answer
40 Results Per Page | Showing 1-14 of 14 Results
| 1
