Results Per Page | Showing 1-6 of 6 Results
| 1
Answer:
Program for dry contact to change state when a fire alarm or a panel trouble condition occurs. The following is for an additional annunciation panel (not a keypad):
...
View Answer
Answer:
No, it is not possible for a user to add or delete user codes through keypad programming. The only similar user code function available is to update a known user code already programmed in system.
View Answer
Answer:
Models: All FireLink, Firewolf* and GEMC* Fire Panels (FL-xxx, FLX2-xxx, GEMC-FW-xxx, GEMC-COMBOxxx)
...
View Answer
Answer:
No, after the control panel is programmed, the AutoLearn feature can no longer be used. A workaround would be to not use SLC addresses one through eight; start your SLC addressing at number nine, then after AutoLearning and uploading the...
View Answer
Answer:
Turn on a blow dryer to its highest "heat" setting and hold 12 inches from the top side inlets of the FWC-FSLC-HEAT detector. Maintain the hot air flow into the inlets until the lights turn red and unit goes into alarm. Turn off the...
View Answer
40 Results Per Page | Showing 1-6 of 6 Results
| 1
