Results Per Page | Showing 1-16 of 16 Results
| 1
Answer:
No, the control panel may utilize zones 1-8 on the FIM module or in the SLC loop, but not both, as the control panel will be unable to determine where the zone is located. With FireLink control panels, there are 2 options:
...
View Answer
Answer:
Yes, you can use every type of Gateway in a single system concurrently with other Gateways, with some limitations.
...
View Answer
Answer:
When discovering Gateways, Expander and Locks you must be on the CA4K Host Server, as a workstation, will not allow wireless services to stop and run.
View Answer
Answer:
Yes. In the Air Access Cloud Web Portal, located under Wireless Configuration, simply select Replace Gateway and follow the prompts.
View Answer
Answer:
One Air Access Gateway can support up to 7 Expanders.
View Answer
Answer:
Use the Gemini C-Series (GEMC) Standby Calculation Worksheet located in our Technical Library website:
...
View Answer
Answer:
The Napco FWC-FSLC-CZM Conventional Zone Module allows the control panel fire SLC (Signaling Line Circuit) loop to interface with and monitor two-wire conventional detectors or pull stations. When used with the GEMC-F8ZCPIM Conventional 8 Fire...
View Answer
Answer:
Refer to the Expander specfication sheet at the following link:
http://tech.napcosecurity.com/index.php/techlibrary/downloadfile/id/2157/embed/iframe
View Answer
Answer:
You can have up to 7 Expanders with 1 Gen II gateway. The gateway and up to 7 expanders must be addressed to the same group number.
View Answer
Answer:
After initial power up, press and hold the RESET button until the red light turns on solid...
...
View Answer
Answer:
YES...
If a trilogy Wireless Lock, Gateway or Expander is reset, it MUST be rediscoved and added back into the CardAccess 3000 software.
View Answer
Answer:
No, after the control panel is programmed, the AutoLearn feature can no longer be used. A workaround would be to not use SLC addresses one through eight; start your SLC addressing at number nine, then after AutoLearning and uploading the...
View Answer
Answer:
For both an 8 and 16 door Accelaterm, the first relay number on the Accelaterm I/O Expander unit is #17.
...
View Answer
Answer:
1) Verify the address jumper is correct on the Alarm Board. The address jumpers are X1, X2, X3 or X4.
...
View Answer
Answer:
No, there is no way to control Fire zones on the Burglary bus. A Fire keypad must be installed on the Fire bus, controlling Fire devices on the Fire bus, either using a GEMC-F8ZCPIM Conventional 8 Fire Zone Expander Plug in Module or through...
View Answer
Answer:
No, there is no way to control Fire zones on the Burglary bus. A Fire keypad must be installed on the Fire bus, controlling Fire devices on the Fire bus, either using a GEMC-F8ZCPIM Conventional 8 Fire Zone Expander Plug in Module or through...
View Answer
40 Results Per Page | Showing 1-16 of 16 Results
| 1
