Results Per Page | Showing 1-7 of 7 Results
| 1
Answer:
Communication Cable for CICP1300IOCOMBO Board
...
View Answer
Answer:
V1.5.0.8 or later supports CICP1300NETBD2 (For CICP1300), CICP2800NETBD2 (For CICP2800), CICP2100/CICP2100S, CA-1, CA-2
...
View Answer
Answer:
CICP1300NETBD - Network adapter for the Super Two.
CICP18ACCNETBD - Network adapter for the Accelaterm and the Accelerator. It is a standard feature on the Accelaterm and optional on the Accelerator
View Answer
Answer:
The BAUD settings for each of the 3 jumpers are:
JUMPER BAUDA -RS485 1200B 2400C 38.4None 9600
D - RS232 1200E 2400F 38.4None 9600
View Answer
Answer:
For the Supertwo and Accelaterm Lantronix XPort, it is recommended not to set a password for Telnet while configuring the XPort. If you set a password and do not remember it, please contact Lantronix for the correct reset procedure.
View Answer
Answer:
Yes...The expansion boards are the same that are used on Super Two controllers.
You must purchase the Supertwo I/O combo unit to use for expansion on the Accelaterm controllers.
View Answer
Answer:
Below is a list of Maximum baud rates for the Continental Controllers?
...
View Answer
40 Results Per Page | Showing 1-7 of 7 Results
| 1
