Results Per Page | Showing 1-6 of 6 Results
| 1
Answer:
When the Air Access Degrade Mode is in effect for a door lock, the lock only uses the Facility Code of the proximity card presented. If that proximity card's Facility Code matches the Facility Code programmed in the lock, the lock will allow...
View Answer
Answer:
To use the AUX relay of a Trilogy Networx™ System NETWORXPANEL Wireless Networx Control Panel that is connected to an Air Access system, configure the Shunt Relay option as follows:
...
View Answer
Answer:
Factory default Alarm Lock devices such as Networx locks, readers, the NETWORXPANEL, etc., that have been discovered and connected to an Air Access system cannot be reverted to their original factory firmware. The Air Access discovery and...
View Answer
Answer:
No, Air Access requires Wiegand readers only. Order any of the compatible readers offered by Alarm Lock, listed below. Do not order Networx DK Panel Packs as the NETPDK and NETDK model keypads are not compatible with the Air Access system. Order the...
View Answer
Answer:
Go into the Access > Personnel screen. Click +ADD PERSONNEL, enter your proximity card number under Badge Number / PIN Only. Next, to enable High Security, set up a numerical PIN code under Two Factor PIN.
...
View Answer
40 Results Per Page | Showing 1-6 of 6 Results
| 1
