Filter By Brand

FAQs By Category

Search FAQs

Search FAQs

Results Per Page | Showing 1-11 of 11 Results | 1

With Gemini C-Series (GEMC) and Firewolf systems, can an end user be programmed to be allowed to add or delete user codes through the keypad?

Answer:
No, it is not possible for a user to add or delete user codes through keypad programming.  The only similar user code function available is to update a known user code already programmed in system.

How do I update the FireLink or GEMC Firewolf control panel firmware using the FireLink Cloud?

Answer:
Models:  All FireLink, Firewolf* and GEMC* Fire Panels (FL-xxx, FLX2-xxx, GEMC-FW-xxx, GEMC-COMBOxxx)
...

How do I set up a FWC-FSLC-SOM1-E Supervised Output Module in place of a NAC Extender with Gemini C-Series (GEMC) control panels (including Firewolf and FireLink panels)?

Answer:
To set up a FWC-FSLC-SOM1-E Supervised Output Module in place of a NAC Extender with GEMINI GEMC series control panels (including Firewolf and FireLink panels), you will need a fire-rated 24VDC power supply and, possibly, a sync module for the...

With FireLink, GEMC and Firewolf control panels, what is an 'E97' trouble and how can I determine its cause?

Answer:
An E97 trouble is an SLC trouble that can be caused by many things. To determine the exact trouble condition, launch PCD-Windows Quickloader and examine the status of the system. In the Status / Control screen, open the SLC tab. The devices in...

How do I program my Gemini C-Series (GEMC) and Firewolf control panel NAC circuits to synchronize System Sensor and/or Wheelock strobes or horn/strobes?

Answer:
Program your Fire zones for the required on-board panel NACs (NAC A and/or NAC D for 32 and 96 zone control panels; NAC A and B or C or D for 128 and 255 zone control panels, shown below).
...

How do I wire and program supervised NAC extenders with my Gemini C-Series (GEMC) and Firewolf control panel?

Answer:
Some fire installations require additional NAC circuits beyond the integral NACs provided on the control panel. All Gemini C-Series (GEMC) and Firewolf control panels have the ability to synchronize up five supervised NAC extenders (using System...

I found older horns and/or 4-wire horn strobes installed in my Gemini C-Series (GEMC) system. How do I wire and program my GEMC control panel to have the panel generate the required Temporal 3 cadence?

Answer:
When retrofitting older GEMC / Firewolf control panels, installers may find older horns and/or 4-wire horn strobes installed.  Unlike the newer smart devices, these older NAC devices may not include a pre-programmed Temporal 3 cadence....

Is more than one Fire Area allowed with the Gemini C-Series (GEMC) control panels?

Answer:
No, the Gemini C-Series (GEMC) Firewolf control panels support one (1) Fire Area only, although up to seven (7) GEMC-FK1 Fire keypads may be programmed into Area 1.  

40 Results Per Page | Showing 1-11 of 11 Results | 1