Filter By Brand

FAQs By Category

Results Per Page | Showing 1-16 of 16 Results | 1

What are the part numbers for the memory coin cells on an Accelaterm?

Answer:
On the Accelaterm, there are two memory coin cells you must be concerned with. The first is on the Interface  board and the second is on the processor board, that is located on the top of the unit. The coin cell battery on the interface board is...

How many backup batteries are required on an Accelaterm?

Answer:
One or two batteries can be used. For 4 hours of standby, two 12V -12AH batteries are required. The batteries should be placed in the bottom right of the cabinet.  
...

What can cause the CICP2100 and CICP2100S (Universe) controllers not to poll?

Answer:
If all the Network settings are correct and the CA4K is programmed correctly, verify the following things:
...

Why is my new Accelaterm (CICP2800) not functioning properly?

Answer:
MOST COMMON ISSUE: Unlike other Continental Controllers, the Accelaterm (CICP2800) does not automatically initiate a firmware download when powered up for the first time. You MUST manually force a firmware download.
...

What is the first Relay number while using an I/O Relay Expander on an Accelaterm?

Answer:
For both an 8 and 16 door Accelaterm, the first relay number on the Accelaterm I/O Expander unit is #17.
...

How do I poll an Accelaterm panel if I do not have a network interface unit?

Answer:
The Accelaterm is shipped with a network interface board as a standard feature. It is recommended to use it.
...

Why are Badge Activity Links not working on Reader 16 of an Accelaterm?

Answer:
Badge Activity Links are not supported on Reader 16 of an Accelaterm.

Why is elevator controls not working on Reader 16 of an Accelaterm?

Answer:
Elevator Controls are not supported on Reader 16 of an Accelaterm.

How do I update the Firmware files in the CardAccess 3000 and CA4K software?

Answer:
There are 4 firmware images in the CardAccess 3000 folder and CA4K folder. The files are smart.img, smart2.img, super2.img, cicp2100.img and accel.img.
...

How do I configure the Relays and Relay Power on the Accelaterm (CICP2800)?

Answer:
WARNING: WHEN APPLYING EXTERNAL POWER INTO JP4, YOU MUST BE VERY CAREFUL WHILE CONFIGURING JUMPERS JP5 AND JP6. FAILURE TO DO SO WILL RESULT IN DAMAGE TO THE UNIT.
...

What is the Mapping for the Inputs on an Accelaterm (CICP2800) 8/16 door controller?

Answer:
Note: An 8 door Accelaterm can have up to 3 I/O expansion boards connected to it.  A 16 door Accelaterm can only have 2 I/O expansion boards connected to it. Each I/O expansion board contains 16 additional inputs and 16 additional...

What is the maximum baud rate for all Continental Controllers (Panels)?

Answer:
Below is a list of Maximum baud rates for the Continental Controllers? 
...

Can I tie inputs together on an Accelaterm, Turbo Superterm, Superterm or a Super Two?

Answer:
Accelaterm = NO Turbo Superterm = NO Superterm = NO Super Two = YES The Super Two is the only controller where the inputs have a common ground.  

40 Results Per Page | Showing 1-16 of 16 Results | 1