Results Per Page | Showing 1-3 of 3 Results
| 1
Answer:
If you are not using Door Contacts (Door Sensors), you must set the Door Sensor =0 under Configuration>Readers and then you MUST perform a DATA DOWNLOAD to the panel. This requirement was added into the Continental Software in 2017.
View Answer
Answer:
Yes, the grounds are common between the +5V accessory power Connector and the Reader Port Ground.
View Answer
Answer:
Note: An 8 door Accelaterm can have up to 3 I/O expansion boards connected to it. A 16 door Accelaterm can only have 2 I/O expansion boards connected to it. Each I/O expansion board contains 16 additional inputs and 16 additional...
View Answer
40 Results Per Page | Showing 1-3 of 3 Results
| 1
