Results Per Page | Showing 1-5 of 5 Results
| 1
Answer:
The Toggle mode (Single Swipe) for Relays is supported in the CardAccess 3000, V2.9.88 and V2.11.x.
...
View Answer
Answer:
VERY IMPORTANT: If possible, name the new computer the same name as the old computer name. This will eliminate some of the most difficult steps in this procedure.
...
View Answer
Answer:
For a photo to pop-up, the alert must be configured to come into the Alert grid (bottom half of screen). If the alert is configured to go directly to the event grid (top half of screen), the photo will not pop up. By default, valid badges are...
View Answer
Answer:
The following are some reasons why this might occur after adding a new panel to the software"
...
View Answer
Answer:
Verify the door sensor is working correctly. If there is no physical door contact, you MUST set the "Door Sensor" setting to zero under "Configuration>Readers>Door Control".
View Answer
40 Results Per Page | Showing 1-5 of 5 Results
| 1
