Results Per Page | Showing 1-12 of 12 Results
| 1
Answer:
For the GEMC Fire Side of the GEMC Control Panel:
...
View Answer
Answer:
Observe the D607 green LED located at the center-right end of the radio PC board. The number of blinks indicates the control panel to which the StarLink Connect radio is set.
...
View Answer
Answer:
The wiring diagram illustrates the connections to a Gemini GEMC Commercial Fire control panel with an SLE-CDMA-FIRE radio mounted remotely (up to 100 feet away). Also shown are the SLE-DLEXT Download Extender Module connections necessary...
View Answer
Answer:
The number of blinks the green LED marked D607 (located at the center right side of the radio PCB) indicates the control panel set in the StarLink Connect radio:
...
View Answer
Answer:
No, the radio must be powered with 12 volts from the GEMC control panel to allow uploading and downloading.
View Answer
Answer:
Used when the SLE-GSM radio is mounted more than 6 feet from the control panel, the SLE-DLEXT is connected between the control panel and the SLE-GSM and provides the means to remotely communicate (download/upload program and status) through the...
View Answer
Answer:
Used when the SLE-GSM radio is mounted more than 6 feet from the control panel, the SLE-DLEXT is connected between the control panel and the SLE-GSM and provides the means to remotely communicate (download/upload program and status) through the...
View Answer
Answer:
To use the "NAPCO Control Panel Serial Port" when using the StarLink SLE-GSM / CDMA radios, the following minimum control panel firmware versions are required:
...
View Answer
Answer:
Yes, the NAPCO StarLink NOC supports arming and disarming through the same cable used for downloading (SLE-DLCBL download cable). Connecting a StarLink radio to a Gemini control panel serial port means there is no longer a need to program and...
View Answer
Answer:
The StarLink SLe-GSM and SLe-GSM-3/4G radios are fully compatible with ALL Gemini control panel versions. The SLe-GSM-8D-3/4G adds compatibility with the Gemini GEM-P400, GEM-P800, GEM-P801, Express XP-400 and XP-800 series control...
View Answer
Answer:
NOTE: This Applies to the Following Products:
...
View Answer
Answer:
Yes. The SLe-GSM can be used to download GEM-P3200 and GEM-P9600 control panels running firmware version 11C or greater, which was released in May of 1999. It can also download to GEM-P816, GEM-P1632 and GEM-P1664 controls running...
View Answer
40 Results Per Page | Showing 1-12 of 12 Results
| 1
