Results Per Page | Showing 1-10 of 10 Results
| 1
Answer:
Some older (version 9, 10, 11) Gemini control panels, including the GEM-P1632, GEM-P1664, PCD-Windows Quickloader to display an error on zone 9 when using Zone Doubling. The solution is to disable the Error Check utility, as follows:
...
View Answer
Answer:
Quickloader - TC/PIP (NL-MOD)........ Port = 10081
...
View Answer
Answer:
When using TCP/IP communications to connect to your Gemini control panels, note the following two options under TCP/IP Communications:
...
View Answer
Answer:
Although most of our Gemini and Gemini C-Series (GEMC) control panels allow the clock to be set using the keypad (Dealer Keypad Program), the clock can also be set using PCD-Windows Quickloader download software. There are two ways to set the...
View Answer
Answer:
Open the Account listings screen that displays a list of your accounts, right-click the account you wish to change and click Edit.
...
View Answer
Answer:
In PCD-Windows Quickloader, check the User Assignment screen, User Report Open/Close tab. Ensure EZ Arm is checked to report openings and/or closings.
...
View Answer
Answer:
In PCD-Windows Quickloader, check the User Assignment screen, User Report Open/Close tab. Ensure Auto Arm/Disarm is checked to report openings and/or closings.
...
View Answer
Answer:
The FWC-FSLC-EZM2 allows two points to be connected to a signal module using one SLC address (for example, connecting a water flow switch/sensor and a gate valve tamper switch to one module). Each point of the FWC-FSLC-EZM2 must be programmed...
View Answer
40 Results Per Page | Showing 1-10 of 10 Results
| 1
