Results Per Page | Showing 1-7 of 7 Results
| 1
Answer:
The only control panels that have integral Auto Disarm scheduling capabilities are the GEM-P3200, GEM-P9600 and GEM-X255 control panels, not the GEM-P1632, GEM-P816 and GEM-P1664 control panels.
...
View Answer
Answer:
The keypad communication bus on all NAPCO control panels is fully self-supervised and will locally annunciate a trouble if for any reason a programmed device does not respond to a control panel poll. Devices connected to the keypad communication bus,...
View Answer
Answer:
Yes. The following is a helpful guide to basic NAPCO Gemini security system operations:
...
View Answer
Answer:
Yes, you can disable the GEM-K1VPS keypad LCD display backlighting on this keypad. You can also have this backlighting auto-dim, and then auto-increase when motion is detected by the integral PIR motion detector (see below for details). ...
View Answer
Answer:
The System Sensor COSMOD2W and COSMOD4W interface modules are UL Listed for use with suitably rated UL Residential and Commercial Fire Alarm Control Panels. In addition, the COSMO-2W 2-wire module does not require a 2-wire compatibility listing...
View Answer
Answer:
(This FAQ applies to all Gemini alarm control panels except the GEM-P400, GEM-P600, GEM-P800 and GEM-P801):
...
View Answer
Answer:
Run PCD-Windows Quickloader software, open the Keypad Assignment screen, ACM Assignment tab. Check the "Enable Napco Proprietary Access Format" check box (or enable location 2780 and add "2"). In addition, ensure a schedule was not...
View Answer
40 Results Per Page | Showing 1-7 of 7 Results
| 1
