FAQs
Can I communicate with the PL3000 using the DL-Windows software only and without enrolling Function Cards?
Yes, you can communicate with the PL3000 using the DL-Windows software only and without enrolling Function Cards. Proceed as follows:
- Open the PL3000 rear cover and remove the battery pack.
- Short the two white wires inside.
- Plug in the (provided) male shunt connector into the yellow wire female connector.
- Reconnect the battery pack with the male shunt connector installed. Listen for slow beeps, indicating the lock is clearing its memory.
- When the LED lights red then green repeatedly, remove the shunt connector (the lock is waiting for communication).
- Within 30 seconds, connect the ALPCI2-U (PC to digital lock interface) cable. In DL-Windows, click the Communication button and click Send. Data will be sent from your computer to the lock.
Note: It is not possible to enroll Function Card # 7 (Toggles Total User Lockout Mode) into the PL3000 using DL-Windows software. See WI1280 for more information.