FAQs
Are there any additional steps I need to perform when programming a Honeywell Vista-21iP control panel with StarLink Connect software?
When programming a Honeywell Vista-21iP control panel using Compass software through the NAPCO StarLink Connect radio software, the following must be performed along with all normal programming steps outlined in the NAPCO StarLink Connect installation instructions:
- Remove power from the control panel by disconnecting AC and battery power.
- On the Vista-21iP motherboard, move the Internal IP/GSM jumper the OFF position.
- Power up the control panel.
- In the control panel programming *29 menu mode, set the internal IP/GSM to DISABLED (refer to the Vista-21iP programming manual if needed).