FAQs
How do I program the StarLink Connect radio for the control panel manufacturer (Napco, Honeywell or DSC) to which it is connected?
After registering the radio at the website www.NapcoCOMnet.com, you must log into the Radio Management Center at www.NapcoNOC.com. Click the StarLink Connect tab, then click Panel Configuration. Select the control panel manufacturer (Napco, Honeywell or DSC), the panel type and enter any other required information. Click Save to retain the radio configuration. The changes will be downloaded to the radio. Note: The unit must be powered for the changes to be received.
For a NAPCO Control Panel:
Select the PANEL TYPE, KEYPAD TYPE, KEYPAD ADDRESS,MASTER CODE and PC SECUIRTY CODE, if used.
(The images below display the various pull-down menus):
When finished, click Save Radio Configurations.
For Honeywell Vista Control Panel:
Select the PANEL TYPE, and Device Address and Partition Number.
When finished, click Save Radio Configurations.
For DSC Control Panel:
Select PANEL TYPE and PARTITION NUMBER.
When finished, click Save Radio Configurations.