FAQs
How can I trigger video upon arming the Alarm System?
Proceed as follows:
Note: To setup your gateway to record video clips upon arming your alarm system, video motion settings must also be enabled and active.
Parts Needed: Model RB1000 Form C Relay Board
1. In the Single Channel Gateway "Advanced Settings" screen (shown below), for the HW Trigger Input feature, select Arm/Disarm. Click Save to continue.
2. Wire a normally closed relay across the "D0" and "Dl" terminals from the RB1000 relay board to the Single Channel Gateway screw terminals (a momentary open across this connection allows triggered video).
3. Wire the RB1000 relay board (+) positive to Aux Power 12V on the control panel. Wire the RB1000 relay board (–) negative to the Armed Lug on the control panel.
- For control panels GEM-P816 / P1632 / P1664 use Lug E15
- For control panels GEM-P3200 / P9600 / GEM-X255 use Lug E4.